Eba 551 Service Manual

Ricoh Priport VT-2100/2130/2150/2300/2500/6000 E 01 Malfunction in cutter section: The cutter motor does not reach both right and left cutter position detecting switches within 2 seconds 1) Drive wire cut 2) Drive section malfunction 3) No power supply E 02 Malfunction in the paper table drive section: The lower limit sensor or the paper table height sensor is not turned off even though the paper table UP or Down signal is applied 1) Drive worm gear broken 2) Mounting screw of the worm gear broken 3) No power supply Apr 01, 2010 . The following is from the Epson Users Manual: Troubleshooting No lights on the control panel Check the power supply cable connections and the power outlet. ERROR LED on (not flashing) with no printing If PAPER OUT is on, the roll paper is not installed or is near the end. If PAPER OUT is off, the printer cover is not closed properly. ERROR LED flashing with no printing (and no paper jam) Printing stops if the head overheats and resumes automatically when it cools. If overheating is not the cause, turn the printer off, and after 10 seconds, back on. Removing Jammed Paper CAUTION: Do not touch the thermal head because it can be very hot after printing.

Turn the printer off and press the cover open button. Remove jammed paper, reinstall the roll, and close the cover. If paper is caught in the cutter and you cannot open the printer cover, open the cutter cover as shown in illustration J. Turn the knob until you see a triangle in the opening. This returns the cutter blade to the normal position. There is a label near the cutter to assist you.